Conducted and radiated emissions to DO160 G - section 21
Objectives
- For designers, anticipation of what will happen to the product during testing, and the possibility of specifying test benches with regard to emission requirements.
- For test technicians, checking set-ups and test equipment
- For project and program managers, to be able decide whether a test report can be used for the compliance matrix.
- Take into account the details required for drafting a reproducible procedure.
Who should attend
- Hardware engineers needing to understand or conduct tests on equipment or systems.
- Technicians following tests or equipment and systems.
- Project managers and program managers validating the testing of equipment for which they are responsible.
- Technicians or engineers writing test procedures
Prerequisites
- Good knowledge of electronic circuits
- Basic EMC couplings
Technical and teaching resources
Presentation aids for lectures, case, demonstration models, test equipment for practical training courses
Sanction of training
Certificate of completion
Methods of assessment
QUIZ evaluation questionnaire
Presentation
The validity of an emissions test depends on many factors. In many cases, elements essential to the relevance of the test are not considered. The main critical points for the relevance of the test are covered during this course.
This training is practically oriented. Conducted and radiated emissions will be measured. The influence of set-ups will be observed.
Program
1 - Mastering the fundamentals of DO160G section 21 testing
- Testing in a Validation & Verification scheme
- Conducting test activity
- General information in DO160G
- Conducted emissions / radiated emissions boundary
2 - Conducting emission tests
- Chambers and associated tools
- Purpose of the test
- Measuring equipment and precautions to be taken
- Test set-up
- Examples of measurements depending on the test set-up
3 - Performing radiated emissions tests
- Purpose of the test
- Measuring equipment and precautions to be taken
- Test set-up
- Example of measurements depending on the test set-up
